Install dhcp relay agent windows server 2003

Select New Routing Protocol from the right context menu. In the New Routing Protocol dialog box , shown in Figure 3. If there are multiple interfaces on your server, choose the one that is on the same subnet as your DHCP clients and click OK. Click OK. EasyProfiter Software. Five Minute Profit Sites. Responses miniya How to install relay agent in server ? Naturally, if the server receives a reply that IP address is not offered.

To set the threshold, right-click the server icon, properties, then Advanced Tab. If all else fails, then clients give themselves an Automatic IP address in the range In NT 4. When you set up a relay agent there are a number of other factors to consider, check your, Hop Count, Boot Threshold, and conflict Detection. My tutorial compares the difficulty of installation with ease of configuring.

Boot Threshold The boot threshold setting is for the cautious or paranoid. Conflict Detection Where you have relay agents, especially if you configure more than one, there is a possibility of duplicate IP addresses.

Microsoft recommends that, each DHCP server in your environment has at least one scope that does not overlap with any other DHCP server scope in your environment. The following sections explain how to troubleshoot some of the issues that you may experience, when you try to install and configure a Windows Server based DHCP server in a workgroup.

This issue can be caused by a network problem, or because the DHCP server is unavailable. When the DHCP server started and other clients can obtain valid addresses, verify that the client has a valid network connection and that all the related client hardware devices including cables and network adapters are working properly.